Explorer Old Man Emu Rear 3 Inch Pin/Pin Shock – Single

Description 1 x OLD MAN EMU Nitrocharger Plus ( 3 inch) Rear Pin/Pin Shock Part Number:- GL2007, MEDIUM Explorer Old Man Emu Rear 3 inch Pin/Pin Shock – Single Part Number:- GL2009, FIRM Explorer Old Man Emu Rear 3 inch Pin/Pin Shock – Single GL2007, These shocks give a Medium Ride, recommended for Defender 90 Rear (light to medium weight Land Rovers) GL2009, These are the same shocks but with firmer valving, better suited for use on the Rear of 110/130s or 90s that are heavily loaded. Manufacturer:- Old Man Emu Weight:- 3.2KG Fits:- Defender 90, 110, 130 with our rear Adventurer / Explorer Pin/Pin Shock Mounts GL1171 Shock Length open:- 615mm Shock Length closed:- 355mm Main Body Diameter:- 58mm Plastic Shroud Diameter:- 69mm These shocks are used for our Explorer 3″ Suspension Kit. This kit uses 2” length shocks on the front and 3” shocks on the rear to give the extra articulation that is needed when going off road. This kit can also be used with or without a suspension lift. A front anti roll bar can be used with a spacer. This suspension kit gives the best of both worlds, on and off road use. For the full description, please see here – Gwyn Lewis Explorer 3″ Suspension Kit & Pricing It is a known problem for the upper Eye fitting on standard fitment rear shocks to break off due to a lack of sideways movement. A Pin fixing allows more movement in all directions without breaking off as has been well proven over the years by my 5inch Challenge Pin/Pin Rear Shock mount. A Pin/Pin Rear Shock provides much improved reliability over the Standard Eye/Pin fitting. 3 inch Shocks – These can be used… • only without Anti Roll Bars fitted • Standard Ride Height up to 3” Lift For longer travel shocks, the following needs to be fitted to the vehicle: Extended brake hoses, spring retainers, and spring Re-locators. And extended bump stops if fitting a spring lift. Protect the shock absorber from paint chips and rust by using this GL1249, Shock Absorber Protection Heat Shrink.    If your Defender 90 is very light on the rear carries no extra weight and would like to improve comfort, then these GL2001 shocks can be fitted to the rear as they are softer valved, you will need our GL1171 Pin/Pin shock mounts to fit them. They come ready assembled with the bushes and our bush isolation washers on each end (these bush isolation washers are very important, to help stop the pin of the shock wearing away, all our shocks come with them ready fitted). See the bush isolation washers here – GL1076. Please click HERE to download the Shock Isolation Washer fitting instructions. The OME Shocks are designed to provide enhanced ride comfort and handling on and off road. Its finely tuned and balanced valving system is among the most advanced on the market.